Frequently Asked Questions

Can't Find Your Question?

Submit your question to FTC

 
 

 

Security : Getting Started/System Basics

Show Topics

Most of the motion detectors installed today discriminate between pets and people. The standard motion detector will discriminate up to a 40lb pet. Depending on the size and number of animals you have a 100lb version is also available.

Helpful?

Be sure the door you are entering is the door you requested for delayed entry/exit. Typically only one door is given delay. If you are now entering through a different door, delay will have to be added. Also be sure the system is not being armed in the instant mode, which will not allow for any re-entry. If you are entering from the correct door and your system is not arming instantly, then there could be a malfunction with the door contact and service may be required.

Helpful?

Normally, the entry delay is set to 45 seconds. The effectiveness of the alarm is dependent on this time being as short as possible. This time can be configured based on your need.

Helpful?

This is normally determined by the installer and is kept to a minimum. We recommend only one door be given delay; however, more can be programmed to suit the customer's needs.

Helpful?

The exact panel location does vary from house to house. Typically they are placed in a closet, laundry room or equipment room. The panel will be housed in a white or tan box mounted on the wall. If our Home Integration Team wired your home, your panel will be housed in your structured wire panel. If you have our wireless system, the control panel is integrated with your main keypad.

Helpful?

Not necessarily, but it is a good idea for someone to be able to gain access to the house in the event of trouble or if the system should malfunction.

Helpful?

With a Napco system, press bypass and the zone number you want bypassed.  With a Honeywell system, enter your four-digit user code followed by the bypass key (6) and the two-digit zone number you wish to bypass. Sequence must be entered continuously or the sequence will not be accepted.

Helpful?

If you hold down the panic or fire alarm buttons on the keypad for 1 to 3 seconds, an alarm is transmitted to the central station, and emergency services are dispatched immediately. An alarm received in this manner cannot be cancelled.
 

Helpful?

Any type of motion sensor should not be armed in the area you are sleeping. If motion sensors are armed in other parts of the house, your system will have to be disarmed before leaving the sleeping quarters. In most cases this has already been programmed for you. You can use the STAY mode while sleeping or are in the house. This feature turns off all interior devices and keeps your perimeter armed. The AWAY feature arms every device in the system and assumes you are leaving the house.

Helpful?

Enter your four-digit code followed by the chime key (9) for Honeywell systems.  For Napco systems, press “function” + 5.

Helpful?

Contact Customer Service at 888-218-5050 for technical support.

 

Helpful?

A solid "Ready" light indicates that the system is ready to be turned on. A blinking "Ready" light indicates that a door or window is open, or there may be movement in the area of a motion detector.

 

Helpful?

Some systems do allow the keypad volume to be increased or decreased. Please refer to your user manual for the procedure for your particular system. For the Lynx Wireless system, press the function key (#) then press the volume key (2) then press the up or down arrow to change the volume level.

Helpful?

The lights on wireless detectors are turned off to help conserve the life of the batteries in the detector.

Helpful?

This normally indicates a malfunctioning siren. Service is required.

Helpful?